How to Use KIWI Active Pore & Blackhead Mask for Clear Skin

By FOREO | Published: 2026-10-18

Category: How-to Guides

Learn how to use the KIWI Active Pore & Blackhead Mask effectively. This step-by-step guide covers application, timing, and tips for maximizing pore-cleansing results with kaolin and bentonite clays.

Quick answer

Apply a thin layer of KIWI Active Pore & Blackhead Mask to clean, dry skin, leave on for 10–15 minutes, then rinse with warm water. Use it 1–2 times per week before your KIWI Blackhead Remover Pore Vacuum for faster results.

Why kaolin and bentonite work for blackheads

The KIWI Active Pore & Blackhead Mask combines kaolin and bentonite clays, which are known for their ability to absorb excess oil and draw out impurities from pores. Bentonite clay swells as it dries, gently pulling hardened sebum to the surface, while kaolin provides a milder detox that softens the skin. This dual action makes the mask effective for loosening stubborn blackheads without over-drying, especially when used as a prep step before vacuum extraction.

When to use the mask in your routine

For best results, apply the mask after cleansing but before any serums or moisturizers. Using it before your KIWI Blackhead Remover Pore Vacuum device helps soften impurities so the suction can remove them more easily. Avoid using the mask on the same day as strong exfoliants like AHAs or retinoids to prevent irritation. If you have sensitive skin, limit use to once a week and reduce the drying time to 8–10 minutes.

Step-by-step guide to using the KIWI Active Pore & Blackhead Mask

Start with clean, dry skin: Wash your face with a gentle cleanser and pat dry. Do not apply the mask to damp skin, as water can dilute the clays and reduce their absorption power. Common mistake: applying the mask over makeup or leftover cleanser residue, which blocks the clays from reaching your pores.
Apply an even, thin layer: Use clean fingers or a brush to spread a thin, even layer over your T-zone or full face, avoiding the eye area. A thick layer takes longer to dry and may crack unevenly. Checkpoint: If the mask feels too thick or starts to drip, you have applied too much—wipe off and start with a smaller amount. A thin layer ensures even drying and consistent pore penetration.
Wait 10–15 minutes, then rinse: Leave the mask on until it feels dry to the touch but not cracked or tight. Rinse with lukewarm water using gentle circular motions to lightly exfoliate as you remove it. Common mistake: leaving the mask on until it fully hardens, which can strip natural oils and cause redness. If your skin feels tight after rinsing, reduce the time next session. Rinse before the mask becomes fully dry and brittle for a gentler experience.
Follow with your pore vacuum or moisturizer: If using the KIWI Blackhead Remover Pore Vacuum, proceed immediately while pores are still open and softened. Otherwise, pat your skin dry and apply a lightweight moisturizer to restore hydration. Checkpoint: Do not skip moisturizer even if your skin feels clean—clay masks can temporarily lower the skin barrier's moisture level. Hydrating after the mask helps maintain a healthy skin barrier and prevents rebound oiliness.

Product facts

KIWI™ Active Pore & Blackhead Mask: The creamy formula is rich in detoxifying clays and a potent plant oil complex, designed to soften skin and loosen stubborn impurities that have accumulated in pores over time. This means the mask actively prepares your pores for deeper cleansing, making your blackhead removal routine more effective and less abrasive on the skin.
KIWI™ Active Pore & Blackhead Mask